Large Load, Powerful, Reliable
Automatic high-pressure steam sterilization
One-time molded stainless steel structure
Plug & Play Installation
Intelligent temperature control, fast heating
High Sterilization Efficiency
Easy To Replace Parts
DESIGN
OPERATE
SAFETY
01
Small foot print
LCD display
Leakage breaker
02
Safety Interlocking
up to 134℃
Safety valve
03
Auto-exhaust
Easy setting
Automatic shutdown
04
Full SS304
Fully automatic
Anti-dry burning
05
Large load
Cycle Time Counter
Overpressure protection
Why we are better
Lid
Bolt type lid structure. Mechanical safety interlocking device.
Display Panel
Microprocessor control system, stable and easy to operate.
Exhaust method
Automatic exhaust, safe and worry-free.
Sterilization
Automatic cycle sterilization program.Takes 35-40 minutes for the ambient temperature to reach 132℃.
Material
All stainless-steel material.
The inner liner is made of extra thick stainless steel, high safety coefficient.
Plug
Come standard with NEMA 10-50P plug. Removable and replaceable.
Lid
Bolt type lid structure. Mechanical safety interlocking device.
Display Panel
Microprocessor control system, stable and easy to operate.
Exhaust method
Automatic exhaust, safe and worry-free.
Sterilization
Automatic cycle sterilization program.Takes 35-40 minutes for the ambient temperature to reach 132℃.
Material
All stainless-steel material.
The inner liner is made of extra thick stainless steel, high safety coefficient.
Plug
Come standard with NEMA 10-50P plug. Removable and replaceable.
HOW TO USE
- Open the lid, add enough water, the water level needs to be higher than the heating tube and the water level sensor (under the inner chamber).
- at the same time, the water level light on the display panel is always on and not blinking (Tips: the water level should not exceed the tripod).
- Each time we use the autoclave, make sure to replenish enough water intime,to avoid burning out the electric heating tube due to lack of water.
1
Step 01
P-1: set it as 102°C-103°C.
When the heating temp. reach 102°C-103°C, the exhaust will close automaticlly. (Default is 102°C)
2
Step 02
P-2: Set the sterilize temperature. Setting range is 105°C-134°C
3
Step 03
P-3: Set the sterilize time, Timer range is 0-9999mins.
4
Step 04 (Optional)
P-4: Set the drying time. （It's optional function, if it's not available in your autoclave, press the SET key to skip.）
5
Step 05
P-5: It's sterilize mode. Press the SET key to skip, no need to change the mode.
6
Step 06
P-6: Counting function. This displays the number of times the autoclave has been used.
7
Sterilize Mode*
- Regarding the settings on the control panel: pcud, pcu5, pf1-l, pfr-5, pp1n, pb1n. this is the sterilization mode setting.
- We don't need to change it, the default program is PFR-5, which is also the standard program of this sterilizer.
- Don't worry if you change any of the parameters, this will not change the sterilization program in the autoclave.
- We just need to turn off the power and reboot, the settings will be automatically reset to PFR-5.
- If the system is not reset, we need to click on ADD KEY until the display shows PFR-5.
8
Exhaust valve*
Automatic exhaust is standard.
Do not operate the exhaust valve manually, keep the exhaust valve closed. (In case of emergency, open it manually for quick venting.）
- Choosing a selection results in a full page refresh.
